Engineering :: Production Engineering
|
|
|
|
|
291. |
Out of the following materials which one is expected to have highest melting point? |
A. |
Silver |
B. |
Gold |
C. |
Lead |
D. |
Palladium |
E. |
Tungsten |
|
|
Answer: Option E
Explanation:
|
292. |
Out of the following materials which one will have lowest temperature of freezing? |
Answer: Option A
Explanation:
|
293. |
Resistance wire strain gauge works on the principle |
A. |
That resistance chanes in proportion to strain on material |
B. |
That resistance of wire changes with load |
C. |
That conductivity is directly proportional to load on member |
D. |
Due to elongation length increases and diameter reduces, thereby resistance changes |
E. |
That the resistance of a wire is directly proportional to diameter and inversely proportional to length |
|
|
Answer: Option D
Explanation:
|
294. |
A rotameter is used to measure |
A. |
rpm of engines |
B. |
Rotation of shafts |
C. |
Twist due to torque applied on shafts |
D. |
Flow of liquids and gases |
E. |
Magnetic flux variation |
|
|
Answer: Option D
Explanation:
|
295. |
For short-distance transmission, the methods of transmission that can be used is |
A. |
Hydraulic |
B. |
Pneumatic |
C. |
Electric and electronic |
D. |
Any of the above |
E. |
None of the above |
|
|
Answer: Option D
Explanation:
|
296. |
Prescribed maximum reading distance for a 100 mm dial is generally |
A. |
1 m |
B. |
1 - 1.5 m |
C. |
1.5 - 2.0 m |
D. |
2.5 - 3 m |
E. |
4 - 5 m |
|
|
Answer: Option D
Explanation:
|
297. |
The most commonly used instrument for the measurement of mass or volume of flowing fluids in industrial plants are |
A. |
Impeller type |
B. |
Propeller type |
C. |
Turbine type |
D. |
Weight belt type |
E. |
Any of the above |
|
|
Answer: Option E
Explanation:
|
298. |
The impedance of piezo-electric crystals is |
A. |
Negligible |
B. |
Very low |
C. |
Low |
D. |
Average |
E. |
High |
|
|
Answer: Option E
Explanation:
|
299. |
Photoelectric transducers are used for the measurement of any phenomenon which can be used to produce |
A. |
Variation in current |
B. |
Variation in voltage |
C. |
Variation in light intensity |
D. |
Variation in flux density |
E. |
Any of the above |
|
|
Answer: Option C
Explanation:
|
300. |
Some substances generate voltage when they are subjected to mechanical forces or stresses along specific planes. Such subtances are known as |
A. |
Thermo-electric |
B. |
Megneto-electric |
C. |
Piezo-electric |
D. |
Photo-electric |
E. |
Radio-active |
|
|
Answer: Option C
Explanation:
|
Read more:
|
|