Engineering :: Foundry Technology
|
|
|
|
|
101. |
Rough surface of casting may result from |
A. |
high permeability of sand |
B. |
large grain size |
C. |
soft ramming |
D. |
any of the above |
Answer: Option D
Explanation:
|
102. |
Which of the following is core hardening process? |
A. |
CO2 process |
B. |
Cold set process |
C. |
Furan system |
D. |
All of the above |
Answer: Option D
Explanation:
|
103. |
Which of the following statement about core is incorrect? |
A. |
core should be permeable to escape of core gases |
B. |
core should be capable of collapsing shortly after the molten metal has solidified around it |
C. |
core should produce maximum amount of gas when in contact with molten metal |
D. |
core should be capable of collapsing after the molten metal has solidified around it |
Answer: Option C
Explanation:
|
104. |
Heating of core is necessary while using which of the following core binder? |
A. |
Phenol formaldehyde resin |
B. |
Phenolic alcohols |
C. |
Furan-base binder |
D. |
All of the above |
Answer: Option D
Explanation:
|
105. |
Chaplets are |
A. |
core binders |
B. |
core supports |
C. |
core projections |
D. |
mould seats to support core |
Answer: Option B
Explanation:
|
106. |
Chaplets are provided to |
A. |
reduce core sag |
B. |
support heavy cores |
C. |
compensate for inadequate coreseats |
D. |
all of the above |
Answer: Option D
Explanation:
|
107. |
Chaplets are made of |
A. |
core sand |
B. |
organic matter |
C. |
wood |
D. |
metal |
Answer: Option D
Explanation:
|
108. |
Tin coated low carbon steel chaplets are used in |
A. |
ferrous foundries |
B. |
non-ferrous foundries |
C. |
both (A) and (B) above |
Answer: Option A
Explanation:
|
109. |
Which of the following statement about gates is incorrect? |
A. |
he size of gate depends upon the rate of solidification |
B. |
A small gate is used for castings which solidify rapidly |
C. |
More than one gate may be used to feed a fast freezing casting |
D. |
A gate should not have sharp edges |
Answer: Option B
Explanation:
|
110. |
The cross-section of a sprue |
A. |
square |
B. |
circular |
C. |
rectangular |
D. |
any of the above |
Answer: Option D
Explanation:
|
Read more:
|
|