Engineering :: Concrete Technology
|
|
|
|
|
81. |
The hardening is the phenomenon by virtue of which |
A. |
the cement does not undergo large change in volume when treted with water |
B. |
the plastic cement paste changes into hard mass |
C. |
the cement paste sets and develops strength |
D. |
none of the above |
Answer: Option C
Explanation:
|
82. |
The phenomenon by virtue of which the cement does not undergo large change in volume when treated with water, is known as |
A. |
fineness |
B. |
soundness |
C. |
setting time |
D. |
none of these |
Answer: Option B
Explanation:
|
83. |
The fineness of cement is measured in terms of |
A. |
percentage weight retained on IS sieve number 9 |
B. |
surface area in cm2 per gram of the cement |
C. |
either (a) or (b) |
D. |
none of these |
Answer: Option C
Explanation:
|
84. |
Too much finencess of cement |
A. |
results cracks in concrete |
B. |
generates greater heat |
C. |
develops early strength |
D. |
both (a) and (b) |
Answer: Option D
Explanation:
|
85. |
The setting time of cement is the governing factor for |
A. |
mixing of concrete |
B. |
placing of concrete |
C. |
compaction of concrete |
D. |
all of these |
Answer: Option D
Explanation:
|
86. |
According to IS : 269 - 1976, the requirement of an ordinary Portland cement is that |
A. |
the residue does not exceed 10% when sieved through IS sieve No. 9 |
B. |
its expansion is not more than 10 mm for unaerated cement |
C. |
its initial setting time is not less than 30 minutes |
D. |
all of the above |
Answer: Option D
Explanation:
|
87. |
The compressive strength of an ordinary Portland cement (1 : 3 cement mortar cube) after 7 days test should not be less than |
A. |
11 N/mm2 |
B. |
17.5 N/mm2 |
C. |
22 N/mm2 |
D. |
27.5 N/mm2 |
Answer: Option B
Explanation:
|
88. |
Vicat's apparatus is used to perform |
A. |
fineness test |
B. |
soundness test |
C. |
consistency test |
D. |
compressive strength test |
Answer: Option C
Explanation:
|
89. |
The knowledge of a standard consistency of a cement paste is essential to perform |
A. |
setting time test |
B. |
soundness test |
C. |
compressive strength test |
D. |
all of these |
Answer: Option D
Explanation:
|
90. |
In Vicat's apparatus, the diameter of Vicat plunger is |
Answer: Option B
Explanation:
|
Read more:
|
|